Missing Perimeter Bar in Edge Beam Reinforcement
Missing Perimeter Bar in Edge Beam Reinforcement is a high-severity structural defect SURE inspectors have documented across 4 inspection reports.
Causes
- Omission during installation
- Construction error
- Non-compliance with structural plans
- Incomplete construction
- Non-compliance with construction plans
Symptoms to look for
- Non-compliance with structural plans
- Missing rebar on pier
- Steel reinforcement not installed as per plans
- Absence of the required edge bar in the steel reinforcement framework for the concrete slab
- Absence of the required internal ribs within the steel reinforcement framework for the concrete slab
Remedies
- Add additional reinforcement bar onto pier as per plans (Rectified onsite)
- Add the perimeter bar on top of the second layer of mesh
- Installation of the missing edge bar to meet plan requirements (completed onsite during inspection)
- Installation of the missing internal ribs to meet plan requirements (completed onsite during inspection)
- Trimmers were installed onsite to meet requirements (Rectified onsite. Defect closed).
Get an inspector through this property.
Findings in this category skew high severity. If you are under contract, we can usually book inside the cooling-off window. Every inspection includes 12 months of free advice.
Curated entries in Structural
- Curated 1–5/5External Wall Cracking Due to Settlement
Cracks in external masonry walls caused by ground movement or differential settlement of the footing system. Most observations are Category 0–2 under the BCA/AS 2870 scale (hairline to 5mm width) and represent cosmetic or minor structural concern, but a small proportion progress to Category 3–5 where structural engineer involvement is required. The crack pattern, location, and change over time determine whether this is a maintenance item or a structural event.
- Curated 1–4/5Obstructed Roof Void due to Insulation
Insulation, HVAC ducting, sarking, or stored items in the roof void prevent a complete inspection of ceiling joists and surrounding timbers. Our inspectors record this limitation because the obstructed zone could harbour undetected timber pest activity, moisture damage, or structural defects - none of which can be reported without visual access.
- Curated 1–5/5Restricted Roof Void Access due to Insulation
Insulation, sarking, HVAC ducting, or low clearance in the roof void prevents a complete visual inspection of ceiling joists, top plates, and perimeter timbers. When these areas are inaccessible, our inspectors cannot confirm whether timber pest activity, moisture damage, or structural defects are present - the limitation itself is a finding that the buyer needs to understand.
- Curated 1–5/5Timber Fungal Decay (Rot) in Fascia and Barge Boards
Fungal decay (wet rot or dry rot) in fascia and barge boards develops when timber is repeatedly wetted and unable to dry out - typically where paint has failed, where roof drainage is defective, or where the boards are end-grain exposed. Left unchecked it spreads into adjacent framing and rafter tails, converting a cosmetic repair into structural work.
- Curated 1–5/5Patched Wall Cracks
Previously cracked walls that have been patched or filled indicate prior ground movement or settlement. While the cosmetic repair may look sound at the time of inspection, the underlying cause - reactive soil movement, differential settlement, or footing inadequacy - may not have been addressed. Patched cracks that re-open signal ongoing movement and warrant structural assessment under AS 2870.
- Curated 1–5/5Leaning Fence Sections
Fence sections leaning out of plumb indicate post footing failure, material deterioration, or soil movement. A significantly leaning fence poses a safety risk - particularly for children - and will continue to worsen without intervention.