Exposed External Power Points
Exposed External Power Points is a high-severity electrical defect SURE inspectors have documented across 4 inspection reports.
Causes
- Water leak (source unspecified, likely from hot water system or external plumbing)
- Incorrect type of power point installed for external use
- Failure of weatherproofing over time
- Exposure to weather conditions
- Inadequate installation
Symptoms to look for
- Potential for failure or electrical safety impact
- Internal-grade power points installed externally
- Power points visible and unprotected outdoors
- Standard indoor power point used outdoors
- Water leaking from inside the power point
Remedies
- Engage a licensed electrician to ensure power point is in good working order and repair any water ingress
- Replace the existing power point with a weatherproof switch/outlet suitable for external conditions
- Engage an electrician to replace with external power point/s
- Install new weather-proof power points outside
- Engage an electrician for repairs
Get an inspector through this property.
Findings in this category skew high severity. If you are under contract, we can usually book inside the cooling-off window. Every inspection includes 12 months of free advice.
Curated entries in Electrical
- Curated 3–5/5Exposed Electrical Wiring in Accessible Area
Electrical wiring not properly enclosed in conduit or behind wall linings in areas accessible to occupants, including subfloor spaces, garages, and laundries. Presents shock hazard and does not comply with AS/NZS 3000 wiring rules.
- Curated 2–5/5Non-Compliant or Overloaded Switchboard
Switchboard not meeting current AS/NZS 3000 requirements, including missing RCDs (safety switches), overcrowded circuits, or outdated ceramic fuses. Common in pre-2000 Perth and Sydney homes that have not been upgraded.