Poor Brickwork Laying or Repair
Poor Brickwork Laying or Repair is a critical finishes defect SURE inspectors have documented across 24 inspection reports.
Causes
- Possibly a failed previous repair of a rusted window lintel
- Poor workmanship during brick laying or pointing
- Poor workmanship in brick laying or repair
- Substandard original construction
- Potential foundation movement
Symptoms to look for
- Visually observable poor quality in a section of brickwork
- Visibly irregular or poorly finished brickwork
- Section not suitable for structural loading
- New window lintel installed nearby
- Poor laying or repair of brickwork
Remedies
- Engage a bricklayer for repairs.
- Request further information pertaining to the completed repair to confirm how the scope was determined, to confirm if a structural engineer was engaged, to confirm if a registered builder was engaged, to determine if the repairing contractor is appropriately insured with public indemnity and to confirm if warranty for the completed works exist.
- Rectify or clean the affected brickwork to improve finish
- Rectify the poor finish to brickwork sections
- Engage a brick layer for repairs
Get an inspector through this property.
Findings in this category skew high severity. If you are under contract, we can usually book inside the cooling-off window. Every inspection includes 12 months of free advice.
Curated entries in Finishes
- Curated 1–3/5Common Cracks and Settlement in Pathways
Cracking and uneven settlement in concrete footpaths, driveways, and porch slabs is one of the most frequently observed external defects in Perth homes, present in 11.66% of all reports. Most findings are minor and reflect the expected behaviour of unreinforced concrete slabs on reactive soils, though tree-root intrusion and poor drainage can accelerate movement to a point where trip hazards develop.
- Curated 1–4/5Surface Rust on Pergola Frame
Surface oxidation on steel pergola frames is one of the more frequent cosmetic findings in Perth pre-purchase reports, appearing in 11.19% of all inspections. Left untreated, surface rust progresses through the coating into the base metal, eventually compromising the structural integrity of posts and beams. Early intervention with surface treatment is straightforward; through-corrosion is not.
- Curated 2–4/5Cracked Floor Tiles in Wet Areas
Cracked, loose, or drummy floor tiles in bathrooms, laundries, and kitchens. Allows moisture penetration to the substrate, potentially compromising waterproof membrane integrity and causing concealed water damage.
- Curated 1–3/5Damaged Eave Lining
Damage to the underside lining of the eaves - including cracking, holes, gaps at junctions, and poorly cut penetrations around downpipes - is recorded in 8.78% of all inspection reports. Beyond the cosmetic concern, openings in eave lining allow birds, possums, and insects to access the roof cavity and can accelerate timber deterioration where moisture also enters.
- Curated 1–3/5Eave Deterioration and Ageing
General weathering and paint breakdown on eave linings, timber rafter ends, and quad trim is one of the most common findings on Perth homes built before 2000. Left unattended, deteriorated eaves allow moisture into the roof perimeter, accelerating rot in rafter ends and creating conducive conditions for timber pests.
- Curated 1–3/5Defective Door Handles, Hinges, and Locks
Malfunctioning or worn door hardware including loose handles, squeaking hinges, misaligned latches, and non-functioning locks. High-frequency defect across all building eras, typically cosmetic but can affect security and fire egress.