Separated Fascia and Barge Board Sections
Separated Fascia and Barge Board Sections is a moderate-severity finishes defect SURE inspectors have documented across 174 inspection reports. Highest concentration in Armadale.
Causes
- Poor installation/maintenance
- Improper installation
- Lack of maintenance
- Minor deterioration
- Structural movement
Symptoms to look for
- Unevenness and/or detachment of fascia and barge boards
- Separated sections of fascia and barge boards
- Section of barge fillet has separated
- Boards separated at a corner joint
- Boards are not straight or level
Remedies
- Engage a qualified carpenter for advice and recommendations.
- Engage a qualified tradesperson for assessment and repair or replacement of affected sections
- A qualified carpenter should be engaged for advice and recommendations
- Engage a carpenter for repairs
- Carry out general upkeep
Where we see this most
These suburbs show the highest concentration of separated fascia and barge board sections in our inspection data (minimum five observations). Click a suburb to see its full defect profile.
Worth asking our inspector about this specifically.
This is common across Perth stock and usually fixable without drama, but the scope of the fix varies. Every SURE inspection includes 12 months of free advice. Call out the defect by name and we check for it directly.
Curated entries in Finishes
- Curated 1–3/5Common Cracks and Settlement in Pathways
Cracking and uneven settlement in concrete footpaths, driveways, and porch slabs is one of the most frequently observed external defects in Perth homes, present in 11.66% of all reports. Most findings are minor and reflect the expected behaviour of unreinforced concrete slabs on reactive soils, though tree-root intrusion and poor drainage can accelerate movement to a point where trip hazards develop.
- Curated 1–4/5Surface Rust on Pergola Frame
Surface oxidation on steel pergola frames is one of the more frequent cosmetic findings in Perth pre-purchase reports, appearing in 11.19% of all inspections. Left untreated, surface rust progresses through the coating into the base metal, eventually compromising the structural integrity of posts and beams. Early intervention with surface treatment is straightforward; through-corrosion is not.
- Curated 2–4/5Cracked Floor Tiles in Wet Areas
Cracked, loose, or drummy floor tiles in bathrooms, laundries, and kitchens. Allows moisture penetration to the substrate, potentially compromising waterproof membrane integrity and causing concealed water damage.
- Curated 1–3/5Damaged Eave Lining
Damage to the underside lining of the eaves - including cracking, holes, gaps at junctions, and poorly cut penetrations around downpipes - is recorded in 8.78% of all inspection reports. Beyond the cosmetic concern, openings in eave lining allow birds, possums, and insects to access the roof cavity and can accelerate timber deterioration where moisture also enters.
- Curated 1–3/5Eave Deterioration and Ageing
General weathering and paint breakdown on eave linings, timber rafter ends, and quad trim is one of the most common findings on Perth homes built before 2000. Left unattended, deteriorated eaves allow moisture into the roof perimeter, accelerating rot in rafter ends and creating conducive conditions for timber pests.
- Curated 1–3/5Defective Door Handles, Hinges, and Locks
Malfunctioning or worn door hardware including loose handles, squeaking hinges, misaligned latches, and non-functioning locks. High-frequency defect across all building eras, typically cosmetic but can affect security and fire egress.